Replacing Drain Stopper In Bathroom Sink

Replacing the Drain Stopper in a Bathroom Sink

A clogged or damaged drain stopper can cause a lot of frustration. If you're dealing with a faulty drain stopper, don't worry - it's a relatively easy fix that you can do yourself. Here's a step-by-step guide on how to replace a bathroom sink drain stopper:

Gather Your Tools and Materials

Before you start, you'll need to gather a few tools and materials. Here's what you'll need:

New drain stopper
Adjustable wrench or pliers
Bucket or bowl
Flashlight (optional)
Putty knife (optional)

Step 1: Remove the Old Drain Stopper

To remove the old drain stopper, you'll need to unscrew the mounting nut that's located underneath the sink. To do this, insert the adjustable wrench or pliers into the nut and turn it counterclockwise. Be careful not to overtighten the nut, as this could damage the sink.

Once the nut is loose, you can remove the drain stopper by pulling it up through the drain hole.

Step 2: Clean the Drain Hole

Before installing the new drain stopper, it's important to clean the drain hole. Use a flashlight to inspect the drain hole for any debris or buildup that could prevent the new drain stopper from forming a proper seal.

If you find any debris, use a putty knife or your fingers to remove it. Once the drain hole is clean, you can proceed to the next step.

Step 3: Install the New Drain Stopper

To install the new drain stopper, simply insert it into the drain hole. Make sure that the gasket or O-ring is in place to create a watertight seal.

Once the drain stopper is in place, secure it by screwing on the mounting nut underneath the sink. Again, be careful not to overtighten the nut.

Step 4: Test the Drain Stopper

Once the new drain stopper is installed, it's important to test it to make sure that it's working properly. Fill the sink with water and then plug the drain stopper. The water should stop draining.

If the water continues to drain, there may be a problem with the seal. Check the gasket or O-ring to make sure that it's in place and that it's not damaged. You may also need to tighten the mounting nut.