How To Replace A Delta Bathroom Faucet

How to Replace a Delta Bathroom Faucet

Replacing a Delta bathroom faucet is a relatively straightforward task that can be completed in under an hour. By following these simple steps, you can easily update the look of your bathroom and ensure that your faucet is functioning properly.

Tools and Materials You'll Need:

Adjustable wrench or basin wrench
Phillips screwdriver
Flathead screwdriver
New Delta bathroom faucet
Plumber's putty
Teflon tape

Step-by-Step Instructions:

1. Turn Off the Water Supply and Drain the Faucet

Before starting any work, turn off the water supply to the faucet. You can do this by locating the shut-off valves beneath the sink or on the main water line. Once the water supply is off, open the faucet to drain any remaining water.

2. Remove the Old Faucet

Use a basin wrench or adjustable wrench to loosen the nuts that hold the faucet in place. Be careful not to damage the sink or countertop. Once the nuts are loose, lift the faucet straight up to remove it.

3. Clean the Mounting Surface

Use a damp cloth to clean the mounting surface of the sink or countertop. Remove any old plumber's putty or debris that may be present.

4. Apply Plumber's Putty and Install the New Faucet

Roll out a small amount of plumber's putty into a rope and form a ring around the base of the new faucet. Place the faucet in the mounting hole and press down firmly to seal it in place.

5. Connect the Water Supply Lines

Wrap the threads of the water supply lines with Teflon tape to prevent leaks. Screw the water supply lines into the corresponding ports on the faucet.

6. Tighten the Nuts and Install the Handles

Use a basin wrench or adjustable wrench to tighten the nuts that hold the faucet in place. Be careful not to overtighten them. Install the faucet handles by sliding them onto the stems and securing them with the included screws.

7. Turn On the Water Supply and Check for Leaks

Turn on the water supply to the faucet and check for any leaks. If you notice any leaks, tighten the nuts or water supply lines as needed. Wipe away any excess water.

Congratulations! You have successfully replaced your Delta bathroom faucet.