How To Install A Moen 2 Handle Bathroom Faucet

How to Install a Moen 2 Handle Bathroom Faucet

Installing a new bathroom faucet can be an easy and rewarding DIY project. With the right tools and a little bit of patience, you can have a new, updated faucet in no time. In this article, we'll walk you through the steps on how to install a Moen 2 handle bathroom faucet.

Tools and Materials you'll need:

Moen 2 handle bathroom faucet
Adjustable wrench
Phillips screwdriver
Pliers
Plumber's putty
Faucet mounting nuts
Basin wrench
Tape measure
Level

Step-by-Step Instructions:

Step 1: Turn Off the Water Supply

Before you start working on the faucet, make sure to turn off the water supply to the bathroom. There should be two shut-off valves under the sink. Turn both of them clockwise to close them.

Step 2: Remove the Old Faucet

Use the adjustable wrench to loosen the nuts that hold the old faucet in place. Once the nuts are loose, you can lift the old faucet off the sink.

Step 3: Clean the Sink Surface

Once the old faucet is removed, clean the sink surface where the new faucet will be installed. Remove any old plumber's putty or debris.

Step 4: Apply Plumber's Putty

Apply a bead of plumber's putty around the base of the new faucet. This will help to create a watertight seal.

Step 5: Install the Mounting Nuts

Thread the faucet mounting nuts onto the faucet shanks. Hand-tighten the nuts as much as possible.

Step 6: Position the Faucet

Place the faucet in the desired position on the sink. Use a level to make sure that the faucet is level.

Step 7: Tighten the Mounting Nuts

Use the adjustable wrench to tighten the mounting nuts. Be careful not to overtighten the nuts, as this could damage the faucet.

Step 8: Connect the Water Supply Lines

Use the basin wrench to connect the water supply lines to the faucet. Make sure that the hot and cold water lines are connected to the correct sides of the faucet.