How Do You Replace A Single Handle Bathroom Faucet

How Do You Replace A Single Handle Bathroom Faucet?

Replacing a single handle bathroom faucet is a relatively simple plumbing repair that can be completed in about an hour. With a few basic tools and a little bit of know-how, you can save yourself the cost of calling a plumber.

Here are the steps on how to replace a single handle bathroom faucet:

Turn off the water supply to the faucet.
There will be two shut-off valves under the sink. Turn both of the valves clockwise until they are completely closed.
Remove the old faucet.
Using a wrench, loosen the nuts that are holding the faucet in place. Once the nuts are loose, you should be able to pull the faucet straight up and out of the sink.
Clean the sink surface.
Before installing the new faucet, it is important to clean the surface of the sink where the faucet will be mounted. This will help to ensure that the new faucet will seal properly.
Install the new faucet.
Place the new faucet in the hole in the sink and tighten the nuts that hold it in place. Be sure to tighten the nuts until they are snug, but do not overtighten them.
Connect the water supply lines.
Connect the hot and cold water supply lines to the new faucet. Be sure to tighten the nuts that hold the lines in place.
Turn on the water supply.
Turn on the shut-off valves under the sink to turn on the water supply to the faucet. Check for leaks around the base of the faucet and the water supply lines.
Adjust the water temperature.
Turn on the faucet and adjust the handle until the water is the desired temperature.

Replacing a single handle bathroom faucet is a simple repair that can be completed in about an hour. With a few basic tools and a little bit of know-how, you can save yourself the cost of calling a plumber.