Changing A Washer On Bathroom Sink Mixer Tap

A dripping tap can be a real nuisance, not to mention a waste of water. If you're experiencing this problem, it's likely that the washer on your bathroom sink mixer tap needs to be replaced. This is a relatively simple job that can be done in a few minutes with the right tools. Here's a step-by-step guide to help you change a washer on a bathroom sink mixer tap:

Step 1: Gather the necessary tools and materials.

You will need the following tools and materials to replace the washer on your bathroom sink mixer tap:

A flathead screwdriver
A Phillips head screwdriver
A pair of pliers
A new washer that is the same size as the old one
A bucket or bowl to catch the water that will drain from the tap

Step 2: Turn off the water supply.

Before you start working on the tap, you need to turn off the water supply. This is usually done by turning the valve located under the sink. If there is no valve, you will need to turn off the main water supply to your home.

Step 3: Remove the aerator.

The aerator is the small screen that is located at the end of the tap. It helps to mix air with the water, which creates a more forceful stream. To remove the aerator, use a pair of pliers to loosen the nut that is holding it in place. Once the nut is loose, you can unscrew the aerator by hand.

Step 4: Remove the cartridge.

The cartridge is the part of the tap that controls the flow of water. To remove the cartridge, you will need to use a flathead screwdriver to pry off the cap that is covering it. Once the cap is removed, you can use a Phillips head screwdriver to loosen the screws that are holding the cartridge in place. Once the screws are loose, you can pull the cartridge out of the tap.

Step 5: Replace the washer.

The washer is located inside the cartridge. To replace it, simply pry off the old washer with a flathead screwdriver and insert the new washer in its place. Make sure that the new washer is facing the right way.

Step 6: Reassemble the tap.

Once you have replaced the washer, you can reassemble the tap. Start by inserting the cartridge back into the tap and tightening the screws. Then, replace the cap that covers the cartridge. Finally, screw the aerator back onto the tap.

Step 7: Turn on the water supply.

Once the tap is reassembled, you can turn on the water supply. Check for leaks around the tap. If there are no leaks, you have successfully replaced the washer on your bathroom sink mixer tap.

Replacing a washer on a bathroom sink mixer tap is a relatively simple job that can be done in a few minutes. By following these steps, you can save yourself the time and expense of calling a plumber.