Remove Bathroom Sink Faucet Handles

Remove Bathroom Sink Faucet Handles: A Step-by-Step Guide

Replacing a bathroom sink faucet is a relatively easy home repair project that can be completed in a few hours. However, before you can replace the faucet, you'll need to remove the handles. Here's a step-by-step guide on how to remove bathroom sink faucet handles:

Step 1: Gather your tools

You'll need the following tools to remove bathroom sink faucet handles:

* Adjustable wrench * Towel * Allen wrench (if applicable)

Step 2: Turn off the water supply

Before you start working on the faucet, turn off the water supply to the sink. There will be two shut-off valves beneath the sink; turn both of them clockwise to close them. Open the faucet to release any remaining water in the pipes.

Step 3: Remove the handle cap

In most cases, the handle cap will be held in place by a small screw. Use a screwdriver to remove the screw, then pull the handle cap straight off.

Step 4: Loosen the handle screw

Once the handle cap is removed, you'll see the handle screw. Use an adjustable wrench to loosen the handle screw, but don't remove it completely.

Step 5: Remove the handle

Once the handle screw is loose, you can remove the handle. If the handle is stuck, you can try gently prying it off with a screwdriver or a butter knife.

Step 6: Remove the cartridge (if applicable)

In some cases, the faucet handle will be attached to a cartridge. If this is the case, you'll need to remove the cartridge before you can remove the handle. To remove the cartridge, use an adjustable wrench to loosen the retaining nut, then pull the cartridge straight out.

Step 7: Reassemble the faucet

Once you've removed the handles, you can reassemble the faucet. Start by inserting the cartridge (if applicable), then tighten the retaining nut. Next, install the handles and tighten the handle screws. Finally, replace the handle caps and turn on the water supply.