How To Clean P Trap In Bathroom Sink

A P-trap is a U-shaped pipe that is installed under a sink or other plumbing fixture. It is designed to trap water in order to prevent sewer gases from escaping into the bathroom. Over time, the P-trap can become clogged with hair, soap scum, and other debris. This can cause the water to drain slowly or even stop draining altogether.

If you notice that your bathroom sink is draining slowly or not draining at all, it is important to clean the P-trap. Here are the steps on how to clean P trap in bathroom sink:

Turn off the water supply to the sink. There should be two shut-off valves under the sink, one for the hot water and one for the cold water. Turn both valves clockwise to turn off the water.
Place a bucket under the P-trap. This will catch the water that drains out when you remove the P-trap.
Loosen the slip nuts on the P-trap. There are two slip nuts that hold the P-trap in place. Use a wrench to loosen the nuts, but do not remove them completely.
Remove the P-trap. Once the slip nuts are loose, you can carefully remove the P-trap. Be careful not to spill any water that is trapped in the P-trap.
Clean the P-trap. Use a brush or a pipe cleaner to clean the inside of the P-trap. Remove any hair, soap scum, or other debris that is clogging the trap.
Reinstall the P-trap. Once the P-trap is clean, you can reinstall it. Place the P-trap back in place and tighten the slip nuts. Make sure that the nuts are tight enough to prevent leaks, but do not overtighten them.
Turn on the water supply to the sink. Check for leaks around the P-trap. If there are any leaks, tighten the slip nuts until the leaks stop.

Cleaning the P-trap is a simple task that can be completed in a few minutes. By following these steps, you can keep your bathroom sink draining properly.