How To Remove A Bathroom Sink From Granite Countertop

How to Remove a Bathroom Sink from a Granite Countertop

Removing a bathroom sink from a granite countertop is not a difficult task, but it does require some care and attention to detail. By following the steps outlined in this guide, you can safely and easily remove your sink without damaging the countertop.

Materials you will need:

Adjustable wrench
Putty knife
Caulk gun
New caulk
Bucket

Step 1: Turn off the water supply

The first step is to turn off the water supply to the sink. This is typically done by turning off the valves located under the sink. Once the water is turned off, open the faucet to release any remaining water from the lines.

Step 2: Disconnect the drain

Next, you will need to disconnect the drain from the sink. To do this, use an adjustable wrench to loosen the nuts that hold the drain in place. Once the nuts are loose, you can pull the drain free from the sink.

Step 3: Disconnect the water lines

Now, you will need to disconnect the water lines from the sink. To do this, use an adjustable wrench to loosen the nuts that hold the water lines in place. Once the nuts are loose, you can pull the water lines free from the sink.

Step 4: Remove the caulk

The next step is to remove the caulk that seals the sink to the countertop. To do this, use a putty knife to carefully cut the caulk around the edge of the sink. Once the caulk is cut, you can gently pry the sink free from the countertop.

Step 5: Clean the countertop

Once the sink is removed, you will need to clean the countertop. Use a damp cloth to wipe away any remaining caulk or debris. Once the countertop is clean, you can apply a new bead of caulk around the edge of the sink. Once the caulk is applied, you can replace the sink in the countertop.

Step 6: Reconnect the water lines

Now, you can reconnect the water lines to the sink. To do this, insert the water lines into the holes in the sink and tighten the nuts that hold them in place. Once the water lines are tight, you can turn on the water supply and check for leaks.

Step 7: Reconnect the drain

Finally, you can reconnect the drain to the sink. To do this, insert the drain into the hole in the sink and tighten the nuts that hold it in place. Once the drain is tight, you can turn on the water and check for leaks.