Removing A Single Handle Bathroom Faucet

Removing a Single Handle Bathroom Faucet: A Step-by-Step Guide

Replacing a bathroom faucet can seem like a daunting task, but it's actually quite easy. With the right tools and a little bit of time, you can have your new faucet installed in no time. Here's a step-by-step guide to removing a single handle bathroom faucet:

Materials you'll need:

Adjustable wrench
Basin wrench
New faucet
Plumber's putty
Teflon tape

Step 1: Turn off the water supply

The first step is to turn off the water supply to the faucet. There are usually two shut-off valves under the sink, one for the hot water and one for the cold water. Turn both valves clockwise to shut off the water.

Step 2: Disconnect the water supply lines

Once the water supply is turned off, you can disconnect the water supply lines from the faucet. Use an adjustable wrench to loosen the nuts that connect the lines to the faucet. Be careful not to overtighten the nuts, as this can damage the lines.

Step 3: Remove the handle

The next step is to remove the handle. There is usually a small screw that holds the handle in place. Remove the screw and pull the handle straight up to remove it.

Step 4: Remove the cartridge

Once the handle is removed, you can remove the cartridge. The cartridge is the part of the faucet that controls the flow of water. Use an adjustable wrench to loosen the nut that holds the cartridge in place. Once the nut is loose, you can pull the cartridge straight out.

Step 5: Install the new cartridge

Take the new cartridge and apply a thin layer of plumber's putty to the base. Insert the cartridge into the faucet and tighten the nut that holds it in place. Be careful not to overtighten the nut, as this can damage the cartridge.

Step 6: Reattach the water supply lines

Reconnect the water supply lines to the faucet. Use an adjustable wrench to tighten the nuts that connect the lines to the faucet. Be careful not to overtighten the nuts, as this can damage the lines.

Step 7: Reinstall the handle

Reinstall the handle by inserting it into the faucet and tightening the screw that holds it in place.

Step 8: Turn on the water supply

Turn on the water supply to the faucet and check for leaks. If there are any leaks, tighten the nuts that connect the water supply lines to the faucet.

And that's it! You've successfully removed your old single handle bathroom faucet and installed a new one.