How To Connect Bathroom Sink Taps

How to Connect Bathroom Sink Taps: A Comprehensive Guide

Installing bathroom sink taps can be a daunting task, but with the right tools and a step-by-step guide, it can be a manageable DIY project. Follow these essential steps to ensure a secure and functional installation:

1. Gather Necessary Tools and Materials

Basin wrench
Adjustable wrench
Plumber's putty
Teflon tape
Compression nuts
Washers
Basin taps

2. Disconnect Water Supply

Locate the shut-off valves under the sink and turn them clockwise to close the water supply. Open the taps to release any residual water.

3. Remove Old Taps

Use the basin wrench to loosen the compression nuts holding the old taps. Carefully remove the nuts and lift out the taps.

4. Prepare New Taps

Apply a bead of plumber's putty around the base of each tap. Wrap Teflon tape around the base of each flexible supply line.

5. Install Taps

Insert the taps into the sink holes and tighten the compression nuts by hand. Use the basin wrench to further tighten the nuts, ensuring they are secure but not overtightened.

6. Connect Supply Lines

Connect the flexible supply lines to the corresponding hot and cold water connectors on the taps. Use the adjustable wrench to tighten the nuts.

7. Test Connections

Turn on the water supply and check for any leaks at the connections. If there are leaks, further tighten the nuts until they stop.

8. Secure Taps

Place a washer on each tailpiece of the taps. Use the adjustable wrench to tighten the nuts holding the tailpieces in place.

9. Finishing Touches

Remove any excess plumber's putty around the base of the taps using a damp cloth. Check that the taps are level and operating smoothly.

Congratulations! You have successfully connected your bathroom sink taps. Enjoy the convenience of fresh, running water without the need for a plumber.