How To Install Drain For Bathroom Sink

How to Install a Drain for a Bathroom Sink

Installing a drain for a bathroom sink is a relatively simple task that can be completed in a few hours. By following these step-by-step instructions, you can ensure that your new drain is installed correctly and is leak-free.

Materials You'll Need:

Pop-up drain assembly
Sink drain stopper
Plumber's putty
Adjustable wrench
Putty knife
Screwdriver

Step-by-Step Instructions:

Remove the old drain. If there is an existing drain, start by removing it. Place a bucket under the sink to catch any water that may drain out. Use an adjustable wrench to loosen the nut that holds the drain in place. Once the nut is loose, carefully remove the drain assembly.
Apply plumber's putty. Roll out a small piece of plumber's putty and form it into a ring. Place the ring of putty around the base of the new drain assembly.
Insert the new drain assembly. Insert the new drain assembly into the drain hole in the sink. Tighten the nut that holds the drain in place using an adjustable wrench. Be careful not to overtighten the nut, as this could damage the sink.
Install the drain stopper. Insert the drain stopper into the drain assembly. The stopper should fit snugly, but not too tightly. You should be able to easily remove the stopper by pulling up on the tab.
Tighten the screws. Use a screwdriver to tighten the screws that hold the drain assembly in place. Be careful not to overtighten the screws, as this could damage the drain assembly.
Test the drain. Turn on the water and allow it to run into the sink. Check for any leaks around the drain. If you see any leaks, tighten the nut or screws as needed.

Tips:

If you are having trouble removing the old drain, you may need to use a penetrating oil to loosen the nut.
Be careful not to overtighten the nut or screws, as this could damage the sink or drain assembly.
If you are not comfortable installing the drain yourself, you can always hire a plumber to do the job.