How To Put Bathroom Sink Back Together

How to Put a Bathroom Sink Back Together

Whether it's for repairs or cleaning, knowing how to disassemble and reassemble a bathroom sink is an essential skill. Follow these steps to do it like a pro:

## Disassembly

1. Shut off the Water Supply:

Turn off the hot and cold water valves under the sink. Check by turning on the faucet; no water should flow.

2. Disconnect the Water Lines:

Using a wrench or pliers, loosen the nuts that connect the supply lines to the faucet. Remove the lines carefully.

3. Disconnect the Drain Line:

Place a bucket under the drain and loosen the slip nut that connects the drain line to the P-trap. Pull the drain line off.

4. Remove the Faucet:

For a single-handle faucet, use a wrench or hex key to remove the handle and cartridge. For a two-handle faucet, unscrew the handles and remove the stems.

5. Remove the Sink:

Support the sink from below and disconnect any clips or brackets that secure it to the countertop. Carefully lift the sink off the countertop.

## Assembly

6. Install the Faucet:

Insert the new faucet into the sinkhole and secure it with the mounting nuts. Connect the water lines to the faucet.

7. Install the Sink:

Apply a bead of silicone sealant around the sink rim. Place the sink on the countertop and connect it to the drain line using the slip nut.

8. Reconnect the Water Lines:

Hand-tighten the nuts that connect the supply lines to the faucet.

9. Install the Drain Line:

Insert the drain line into the sink drain hole and secure it with the slip nut.

10. Test the Sink:

Turn on the water supply and check for leaks. Adjust the nuts and connections as needed to prevent leaks, but avoid overtightening.

## Tips * Use plumber's tape on all threaded connections to ensure a watertight seal. * Be gentle when tightening the nuts and screws. Overtightening can damage the components. * If you encounter any difficulties, don't hesitate to seek professional help.