How To Install Drain In Bathroom Vanity

How to Install a Drain in a Bathroom Vanity

Installing a drain in a bathroom vanity is a relatively simple task that can be completed in a few hours. By following these step-by-step instructions, you can ensure that your drain is installed correctly and will provide years of trouble-free use.

Materials Needed:

Pop-up drain assembly
Slip joint pliers
Adjustable wrench
Plumber's putty
Flashlight (optional)

Step-by-Step Instructions:

1. Remove the old drain (if necessary): If there is an existing drain in the vanity, you will need to remove it before installing the new one. To do this, use a slip joint pliers to loosen the nuts that hold the drain in place. Once the nuts are loose, you can remove the drain by pulling it up and out of the vanity.

2. Apply plumber's putty to the drain flange: Before installing the new drain, you will need to apply a bead of plumber's putty to the drain flange. This will help to create a watertight seal between the drain and the vanity.

3. Install the drain in the vanity: Once the plumber's putty has been applied, you can install the new drain in the vanity. To do this, insert the drain flange into the drain hole in the vanity. Then, tighten the nuts that hold the drain in place using an adjustable wrench.

4. Connect the drain to the P-trap: Once the drain is installed, you will need to connect it to the P-trap. To do this, insert the P-trap into the drainpipe. Then, tighten the nuts that hold the P-trap in place using an adjustable wrench. Note: Use the flashlight to find the nuts for easier installation.

5. Test the drain: Once the drain is installed, you should test it to make sure that it is working properly. To do this, turn on the water and allow it to run into the sink. The water should drain out of the sink quickly and smoothly. If the water does not drain properly, you may need to adjust the drain or tighten the nuts that hold it in place.

Congratulations! You have now successfully installed a drain in your bathroom vanity.