How To Replace Bathroom Vanity Taps

Replacing bathroom vanity taps is an essential task for any homeowner. It is a relatively straightforward process that can be completed in a few hours with the right tools and materials. By following these steps, you can ensure that your new taps are installed correctly and will last for years to come.

The first step is to gather the necessary tools and materials. You will need a wrench, a screwdriver, a pair of pliers, a basin wrench, and a new set of taps. You may also need some Teflon tape or plumber's putty to seal the connections.

Once you have gathered your tools and materials, you can begin the process of removing the old taps. First, turn off the water supply to the taps. Then, use the wrench to loosen the nuts that hold the taps in place. Once the nuts are loose, you can use the pliers to remove the taps from the sink.

Next, you will need to install the new taps. First, apply a small amount of Teflon tape or plumber's putty to the threads of the new taps. Then, screw the taps into the sink by hand. Once the taps are hand-tight, you can use the wrench to tighten them further.

Finally, you will need to reconnect the water supply to the taps. First, turn on the water supply and check for leaks. If there are no leaks, you have successfully replaced your bathroom vanity taps.

Replacing bathroom vanity taps is a relatively simple process that can be completed in a few hours. By following these steps, you can ensure that your new taps are installed correctly and will last for years to come.