How To Install Bathroom Cabinet Door Hinges

Installing bathroom cabinet door hinges is a simple process that can be completed in a few steps. By following these instructions, you can ensure that your cabinet doors are properly aligned and functioning smoothly.

1. Gather Your Materials

Before you begin, you will need to gather the following materials:

A cordless drill
A drill bit that is the same size as the hinge screws
A Phillips head screwdriver
A tape measure
A level
A pencil
Cabinet door hinges
Screws

2. Measure and Mark the Hinge Locations

The first step is to measure and mark the locations of the hinges on the cabinet door and the cabinet frame. To do this, follow these steps:

Measure the width of the cabinet door and divide it by 2. This will give you the center point of the door.
Mark the center point on the top and bottom edges of the door.
Measure the height of the cabinet door and divide it by 4. This will give you the center point for the top and bottom hinges.
Mark the center points on the sides of the door.
Transfer the hinge locations to the cabinet frame by measuring and marking the corresponding points on the inside of the frame.

3. Drill Pilot Holes

Once you have marked the hinge locations, you need to drill pilot holes for the screws. To do this, follow these steps:

Align the drill bit with the hinge location marks on the door and frame.
Drill pilot holes that are slightly smaller than the diameter of the screws.

4. Install the Hinges

Now you are ready to install the hinges. To do this, follow these steps:

Place the hinges over the pilot holes on the door and frame.
Secure the hinges with screws.
Repeat this process for all of the hinges.

5. Adjust the Hinges

Once the hinges are installed, you need to adjust them so that the door is properly aligned. To do this, follow these steps:

Open and close the door to check the alignment.
If the door is not aligned, use a screwdriver to adjust the screws on the hinges.
Continue adjusting the hinges until the door is properly aligned.