How To Remove An Old Bathroom Fan Housing

Removing an old bathroom fan housing is a relatively simple task that can be completed in a few hours. However, it is important to take the necessary safety precautions and to follow the steps carefully to avoid damaging the wall or the electrical system.

The first step is to turn off the power to the bathroom fan at the circuit breaker panel. Once the power is off, you can remove the cover plate from the fan housing using a screwdriver. Next, you will need to disconnect the electrical wires from the fan motor. Use a pair of wire cutters to cut the wires, and then use a screwdriver to remove the wire nuts. Once the wires are disconnected, you can remove the fan motor from the housing by unscrewing the mounting screws.

Once the fan motor is removed, you can remove the housing from the wall. Use a screwdriver to remove the screws that are holding the housing in place. Once the screws are removed, you can carefully pull the housing away from the wall. Be careful not to damage the drywall or the electrical wires.

Once the housing is removed, you can clean the area and install the new fan housing. Follow the manufacturer's instructions for installing the new fan housing. Once the new fan housing is installed, you can reconnect the electrical wires and install the fan motor.

Finally, you can install the cover plate and turn on the power to the bathroom fan. Your bathroom fan should now be working properly.