Replacing A Single Hole Bathroom Faucet

Replacing a single hole bathroom faucet is a relatively straightforward task that can be completed in a few hours. By following these step-by-step instructions, you can save yourself the cost of hiring a plumber.

Tools and Materials You'll Need:

Adjustable wrench
Basin wrench
Channel-lock pliers
New faucet
Plumber's tape
rags

Step-by-Step Instructions:

1. Turn Off the Water Supply:

Locate the water supply lines under the sink and use the adjustable wrench to turn off the hot and cold water valves.

2. Disconnect the Old Faucet:

Use the basin wrench to loosen the nuts that hold the faucet in place. Carefully pull the faucet up and out of the sinkhole.

3. Clean the Sinkhole:

Use rags to remove any old putty or debris from the sinkhole.

4. Apply Plumber's Tape:

Wrap plumber's tape around the threads of the new faucet's mounting bolts. This will help to create a watertight seal.

5. Install the New Faucet:

Insert the new faucet into the sinkhole and tighten the mounting bolts with the basin wrench.

6. Reconnect the Water Lines:

Use the adjustable wrench to reconnect the hot and cold water lines to the new faucet. Be sure to tighten the nuts firmly but not too tightly.

7. Turn On the Water Supply:

Slowly turn on the water valves under the sink and check for any leaks. Tighten any loose connections if necessary.

Tips:

If you encounter any difficulty removing the old faucet, try using channel-lock pliers to break it loose.
Be careful not to overtighten the mounting bolts, as this can damage the faucet or the sink.
If you are replacing a faucet with a different type of handle, you may need to adjust the drain stopper accordingly.

By following these instructions, you can easily and safely replace a single hole bathroom faucet. Save yourself the cost of a plumber and enjoy the satisfaction of completing a DIY project.