How To Fit A Bathroom Tap

Fitting a bathroom tap may seem like a daunting task, but with the right tools and a bit of planning, it's a job that can be easily completed in a few hours. ### Tools You'll Need Before you start, make sure you have all the necessary tools to hand, including: - Adjustable spanner - Plumber's wrench - Screwdriver - PTFE tape - New tap - Bucket or bowl ### Step-by-step Guide 1.

Turn off the water supply.

This is usually done by turning off the stopcock under the sink or basin. 2.

Remove the old tap.

Use the adjustable spanner to loosen the nuts that hold the tap in place. Once the nuts are loose, you can pull the tap out of the hole. 3.

Clean the surface.

Once the old tap is removed, clean the surface around the hole with a damp cloth. This will help to ensure that the new tap fits snugly. 4.

Wrap the threads with PTFE tape.

This will help to create a watertight seal. Wrap the tape clockwise around the threads, starting at the bottom. 5.

Fit the new tap.

Insert the new tap into the hole and tighten the nuts until they are snug. Don't overtighten the nuts, as this could damage the tap. 6.

Connect the water supply.

Use the plumber's wrench to connect the water supply hoses to the tap. Make sure that the hoses are tightened securely. 7.

Test the tap.

Turn on the water supply and check for any leaks. If there are any leaks, tighten the nuts further until the leak is stopped. ### Troubleshooting Tips If you encounter any problems when fitting your bathroom tap, here are a few troubleshooting tips: - If the tap is leaking, check that the nuts are tightened securely. You may also need to replace the washer or O-ring. - If the tap is not working properly, check that the water supply is turned on and that there are no kinks in the hoses. - If the tap is loose, check that the nuts are tightened securely. You may also need to add some sealant around the base of the tap.