How To Uninstall Old Bathroom Faucet

How to Uninstall an Old Bathroom Faucet

Uninstalling an old bathroom faucet is a relatively simple plumbing task that can be completed in a few minutes with the right tools. By following these step-by-step instructions, you can easily remove your old faucet and install a new one.

Tools and Materials You'll Need

Adjustable wrench
Basin wrench
Plumber's putty
Clean cloths and rags

Step-by-Step Instructions

1. Turn off the water supply. This is usually done by closing the shut-off valves under the sink. 2. Disconnect the water lines. Use a basin wrench to loosen the nuts that connect the supply lines to the faucet. Be careful not to overtighten the nuts, as this can damage the lines. 3. Remove the faucet handle. Most faucet handles are held in place by a screw. Remove the screw and then pull the handle straight up to remove it. 4. Unscrew the mounting nuts. Use an adjustable wrench to loosen the mounting nuts that hold the faucet in place. Be careful not to overtighten the nuts, as this can damage the faucet. 5. Remove the faucet. Once the mounting nuts are loose, you should be able to pull the faucet straight up to remove it. 6. Clean the sink surface. Use a clean cloth and rags to clean the sink surface where the faucet was installed. This will help to remove any debris or old sealant. 7. Apply plumber's putty. Roll out a small amount of plumber's putty and then apply it to the underside of the new faucet. This will help to seal the faucet and prevent leaks. 8. Place the new faucet. Carefully place the new faucet into the sink opening. Make sure that the faucet is level and that the plumber's putty is evenly distributed. 9. Tighten the mounting nuts. Use an adjustable wrench to tighten the mounting nuts that hold the faucet in place. Be careful not to overtighten the nuts, as this can damage the faucet. 10. Connect the water lines. Use a basin wrench to connect the supply lines to the faucet. Be careful not to overtighten the nuts, as this can damage the lines. 11. Turn on the water supply. Open the shut-off valves under the sink to turn on the water supply. Check for any leaks around the faucet. If there are any leaks, tighten the mounting nuts or the water lines until the leaks stop.

Conclusion

Uninstalling an old bathroom faucet is a simple task that can be completed in a few minutes. By following these step-by-step instructions, you can easily remove your old faucet and install a new one.