How To Replace Bathroom Faucet Drain

Replacing a bathroom faucet drain is a relatively easy task that can be completed in a few minutes with the right tools. By following these simple steps, you can quickly and easily replace your old drain and get your bathroom sink working properly again.

Tools You Will Need:

Adjustable wrench
Phillips screwdriver
Flathead screwdriver
New drain assembly

Step-by-Step Instructions:

Turn off the water supply. Locate the water supply valves underneath the sink and turn them off. This will prevent water from leaking out when you remove the old drain.
Remove the old drain. Use the adjustable wrench to loosen the nut that holds the drain in place. Once the nut is loose, you can remove the old drain by hand.
Clean the drain hole. Use a cloth or sponge to clean the drain hole. Remove any dirt or debris that may have accumulated.
Install the new drain. Place the new drain assembly into the drain hole. Tighten the nut by hand until it is snug. Then, use the adjustable wrench to tighten the nut further.
Connect the drain to the P-trap. Use the Phillips screwdriver to tighten the screws that connect the drain to the P-trap. Make sure the connection is tight, but do not overtighten the screws.
Turn on the water supply. Turn on the water supply valves underneath the sink. Check for leaks around the drain. If you see any leaks, tighten the nuts or screws until the leak stops.

Tips:

If you are having difficulty removing the old drain, you can use a flathead screwdriver to pry it loose.
Be careful not to overtighten the nuts or screws. This can damage the drain or the P-trap.
If you are not comfortable replacing the drain yourself, you can call a plumber for assistance.