How To Change A Mixer Tap In Bathroom

Changing a mixer tap in the bathroom is a relatively simple task that can be completed in a few hours. By following these step-by-step instructions, you can save yourself the cost of hiring a plumber.

Essential Aspects of Changing a Mixer Tap in the Bathroom

Before changing out a mixer tap, it is essential to consider the following factors:

The type of tap: There are two main types of mixer taps: single-lever and dual-lever. Single-lever taps have one lever that controls both the hot and cold water, while dual-lever taps have two levers, one for each type of water.
The size of the tap: Mixer taps come in a variety of sizes. It is essential to measure the space where you plan to install the tap before purchasing one.
The finish of the tap: Mixer taps are available in a variety of finishes, including chrome, brushed nickel, and oil-rubbed bronze. Choose a finish that will complement the décor of your bathroom.

Tools and Materials

Before you begin, you will need to gather the following tools and materials:

Adjustable wrench
Plumber's putty
Teflon tape
New mixer tap

Step-by-Step Instructions

Now that you have gathered your tools and materials, you can follow these step-by-step instructions to change the mixer tap in your bathroom:

Turn off the water supply: The first step is to turn off the water supply to the bathroom. This is typically done by turning off the valves under the sink.
Disconnect the old tap: Once the water supply is turned off, you can disconnect the old tap. To do this, use an adjustable wrench to loosen the nuts that secure the tap to the sink.
Apply plumber's putty: Before installing the new tap, apply a bead of plumber's putty around the base of the tap.
Install the new tap: Place the new tap into the sink and tighten the nuts that secure it. Be sure to tighten the nuts evenly to prevent leaks.
Connect the water supply: Once the new tap is installed, you can connect the water supply. To do this, turn on the valves under the sink and check for leaks.
Wrap with Teflon tape: If you notice any leaks, you can wrap the threads of the water supply lines with Teflon tape. This will help to create a watertight seal.

Conclusion