How To Replace Oval Bathroom Sink Tap

Replacing an oval bathroom sink tap is a relatively simple task that can be completed in a few hours. By following these steps, you can easily replace your old tap with a new one.

Tools and materials you'll need:

Adjustable wrench
Channel-type pliers
Basin wrench
New oval bathroom sink tap
Plumber's putty or silicone sealant
Teflon tape
Bucket

Step-by-step instructions:

1. Turn off the water supply to the sink. There should be two shut-off valves under the sink, one for the hot water and one for the cold water. Turn both valves clockwise to turn off the water.

2. Disconnect the water supply lines from the old tap. Use an adjustable wrench to loosen the nuts that connect the water supply lines to the tap. Be careful not to overtighten the nuts, as you could damage the lines.

3. Remove the old tap. Use a basin wrench to loosen the nuts that hold the tap in place. Once the nuts are loose, you should be able to lift the tap off the sink.

4. Apply plumber's putty or silicone sealant to the base of the new tap. This will help to create a watertight seal between the tap and the sink.

5. Place the new tap on the sink. Align the tap with the holes in the sink and then tighten the nuts that hold it in place. Be sure to tighten the nuts evenly so that the tap is secure.

6. Connect the water supply lines to the new tap. Use an adjustable wrench to tighten the nuts that connect the water supply lines to the tap. Be careful not to overtighten the nuts, as you could damage the lines.

7. Turn on the water supply to the sink. Check for leaks around the base of the tap and the water supply lines. If you see any leaks, tighten the nuts until the leaks stop.

8. You have now successfully replaced your oval bathroom sink tap.