How To Remove Pop Up Drain In Bathroom Sink

Removing a Pop-Up Drain in a Bathroom Sink

Pop-up bathroom sink drains provide a convenient and stylish way to control water flow. However, when they become clogged or malfunction, it's necessary to remove them for cleaning or replacement. Here's a step-by-step guide to help you safely remove a pop-up drain in your bathroom sink.

Materials Required:

* Adjustable wrench or pliers * Screwdriver * Rag or towel

Safety Precautions:

* Turn off the water supply to the sink before starting. * Wear gloves to protect your hands from sharp edges. * Place a rag or towel around the drain opening to prevent water and debris from spilling onto the floor.

Step-by-Step Instructions:

1. Remove the Drain Stopper:

Use the pliers or your hand to gently pry the drain stopper up and out of the drain. It may be held in place by a small screw or friction from the O-ring.

2. Adjust the Linkage:

Locate the linkage that connects the drain stopper to the drain assembly. It usually consists of a metal rod or chain. Use the adjustable wrench or pliers to loosen the linkage nut and disconnect it from the drain stopper.

3. Loosen the Retainer Nut:

Underneath the sink, find the retainer nut that holds the drain assembly in place. Use the adjustable wrench or pliers to turn the nut counterclockwise to loosen it.
. Note: Some pop-up drains may have a locking mechanism that requires a screwdriver to disengage before loosening the nut.

4. Withdraw the Drain Assembly:

Gently pull the drain assembly up and out of the sink. Be careful not to damage the sink or the drain assembly.

5. Clean or Replace:

Inspect the drain assembly and clean any debris or clogs. If the drain assembly is damaged or worn out, it should be replaced.
. Tips:
. - You may need to use a screwdriver to gently pry around the base of the drain assembly to break it loose.
. - Apply a small amount of plumber's grease or petroleum jelly to the O-rings of the new drain assembly before installing it.

6. Reinstall the Drain Assembly:

Align the new or cleaned drain assembly with the sink drain hole and insert it. Tighten the retainer nut underneath the sink by hand, then use the wrench or pliers to snug it further.

7. Connect the Linkage:

Reattach the linkage to the drain stopper and tighten the linkage nut.

8. Reinstall the Drain Stopper:

Place the drain stopper back into the drain opening and gently press down to reseat it.

9. Turn On the Water:

Turn on the water supply to the sink and check for any leaks. Congratulations! You have successfully removed and reinstalled the pop-up drain in your bathroom sink.