Installing Pvc Pipe Under Bathroom Sink

By | February 11, 2020

Installing PVC Pipe Under Bathroom Sink: A DIY Guide

Replacing or installing PVC pipe under a bathroom sink is a relatively simple plumbing task that most homeowners can do themselves with a few basic tools. By following these step-by-step instructions, you can save money and avoid the hassle of calling a plumber.

Step 1: Gather Your Materials

Before you start, gather the following materials:

  • PVC pipe (1-1/2 inch or 2 inch diameter)
  • PVC pipe cutter
  • PVC primer and cement
  • PVC couplings
  • PVC tee fittings
  • 45-degree PVC elbows
  • Pipe clamps
  • Measuring tape

Step 2: Measure and Cut the Pipe

Measure the distance from the drain flange to the desired location of the p-trap. Cut the PVC pipe to this length using the PVC pipe cutter.

Step 3: Assemble the Drain Assembly

Connect the pipe you just cut to the drain flange using a coupling. Attach a 45-degree elbow to the other end of the pipe.

Step 4: Install the P-trap

Connect a tee fitting to the elbow. Insert the vertical leg of the tee into the p-trap and connect the horizontal leg of the tee to the drainpipe.

Step 5: Connect the Sink Drain

Connect the sink drainpipe to the p-trap using a coupling. Make sure that the connection is tight and secure.

Step 6: Dry Fit the Assembly

Before gluing the pipes together, dry fit the assembly to make sure that everything fits correctly. Mark the pipes where they overlap.

Step 7: Prime and Glue the Joints

Apply PVC primer to the inside of the pipe and the outside of the fitting. Let the primer dry for a few minutes, then apply PVC cement to both surfaces. Quickly insert the pipe into the fitting and hold it in place for a few seconds until the cement sets.

Step 8: Secure the Pipes

Once the cement has set, use pipe clamps to secure the joints and prevent movement. Let the cement cure for several hours before using the sink.

Tips for Success:

Use a sharp PVC pipe cutter to make clean cuts.

Clean the pipe ends thoroughly before gluing.

Apply the PVC cement evenly and avoid using too much.

Hold the joints in place firmly until the cement has set.

Check for leaks by turning on the water supply and inspecting the joints.



How To Plumb A Drain Sink Pipes

How To Plumb A Drain Sink Pipes

Replace A Trap And Add Cleanout

Replace A Trap And Add Cleanout Fine Homebuilding

How To Install Bathroom Sink Drain

How To Install Bathroom Sink Drain Queen Bee Of Honey Dos

How To Install A Flexible Waste Pipe

How To Install A Flexible Waste Pipe When The Drain Doesn T Line Up Handyman S Daughter

How To Install A Kitchen Sink And Drain

How To Install A Kitchen Sink And Drain For Beginners Church Flip Episode 7

Bathroom Sink Plumbing Installation

Bathroom Sink Plumbing Installation Diy Montreal

J Pipe Under A Bathroom Sink

How To Change J Pipe Under A Bathroom Sink Ehow

Sink Plumbing

How To Retrieve An Item Dropped Down The Sink Drain In 2024 Bathroom Plumbing Replace

Replacing Kitchen Sink Pvc Pipes

Replacing Kitchen Sink Pvc Pipes Washers P Trap Center Joints And Arms W Dishwasher Attachment

Bathroom Sink Plumbing Installation

Bathroom Sink Plumbing Installation Diy Montreal


Leave a Reply

Your email address will not be published. Required fields are marked *