How To Fit A Bathroom Basin Mixer Tap

How to Fit a Bathroom Basin Mixer Tap

Fitting a bathroom basin mixer tap is a relatively straightforward task that can be completed in around an hour. By following these simple steps, you can save yourself the cost of calling out a plumber.

Tools and materials you will need:

New basin mixer tap
Adjustable spanner
Screwdriver
Plumber's tape
Cloth or sponge

Step 1: Turn off the water supply

The first step is to turn off the water supply to your bathroom. This is usually done by turning the stopcocks located under the sink. If you cannot find the stopcocks, you will need to turn off the main water supply to your home.

Step 2: Disconnect the old tap

Once the water supply is turned off, you can disconnect the old tap. To do this, use an adjustable spanner to loosen the nuts that are holding the tap in place. Once the nuts are loose, you can pull the tap away from the sink.

Step 3: Clean the surface

Before fitting the new tap, it is important to clean the surface of the sink where the tap will be fitted. This will help to ensure a good seal and prevent leaks.

Step 4: Apply plumber's tape

Once the surface is clean, apply a few wraps of plumber's tape to the threads of the new tap. This will help to create a watertight seal.

Step 5: Fit the new tap

Now you can fit the new tap. To do this, simply push the tap into place and tighten the nuts using an adjustable spanner. Be careful not to overtighten the nuts, as this could damage the tap.

Step 6: Connect the water supply

Once the tap is fitted, you can connect the water supply. To do this, simply attach the flexible hoses to the stopcocks under the sink. Tighten the nuts using an adjustable spanner.

Step 7: Test the tap

Finally, turn on the water supply and test the tap. Check for any leaks and make any necessary adjustments.

Congratulations! You have now successfully fitted a bathroom basin mixer tap.