How To Put Faucet In Bathroom Sink

Replacing a bathroom sink faucet is a relatively simple plumbing project that can be completed in a few hours with the right tools and materials. By following these step-by-step instructions, you can easily update the look of your bathroom.

Before you begin, gather the necessary tools and materials. You will need a new faucet, a basin wrench, a pair of pliers, a screwdriver, and a plumber's putty. Once you have everything you need, you can begin the process of removing the old faucet and installing the new one.

Step 1: Turn Off the Water Supply

The first step is to turn off the water supply to the sink. There are usually two shut-off valves located under the sink, one for the hot water and one for the cold water. Turn both valves clockwise to turn off the water supply.

Step 2: Disconnect the Water Supply Lines

Once the water supply is turned off, you can disconnect the water supply lines from the faucet. Use a basin wrench to loosen the nuts that connect the water supply lines to the faucet. Once the nuts are loose, you can pull the water supply lines off of the faucet.

Step 3: Remove the Old Faucet

Once the water supply lines are disconnected, you can remove the old faucet. Use a screwdriver to remove the screws that hold the faucet in place. Once the screws are removed, you can lift the faucet up and off of the sink.

Step 4: Apply Plumber's Putty

Before you install the new faucet, you need to apply a bead of plumber's putty around the base of the faucet. Plumber's putty is a type of sealant that helps to prevent water from leaking around the faucet.

Step 5: Install the New Faucet

Once you have applied the plumber's putty, you can install the new faucet. Place the faucet in the hole in the sink and press down on it to secure it. Once the faucet is in place, you can tighten the nuts that hold it in place.

Step 6: Connect the Water Supply Lines

Once the faucet is installed, you can connect the water supply lines. First, apply a small amount of thread sealant to the threads of the water supply lines. Then, screw the water supply lines onto the faucet. Tighten the nuts until they are snug.

Step 7: Turn on the Water Supply

Once the water supply lines are connected, you can turn on the water supply. First, turn on the hot water valve, then turn on the cold water valve. Check for any leaks around the faucet. If you see any leaks, tighten the nuts on the water supply lines until the leaks stop.

Step 8: Finish Up

Once the faucet is installed and there are no leaks, you can finish up. Install the handles on the faucet, and then insert the drain stopper. Your new faucet is now installed and ready to use.