How To Replace Drain Stopper Bathroom Sink

How to Replace a Bathtub or Sink Drain Stopper

A bathroom sink drain stopper can become worn, damaged, or lost over time. Replacing it is a relatively easy task that can be completed in a few minutes with a few simple tools. Here are the steps on how to replace a drain stopper in a bathroom sink:

Tools and Materials Needed:

Phillips head screwdriver
Adjustable wrench
New drain stopper

Steps:

1. Turn off the water supply to the sink. This is typically done by turning off the valves under the sink. If you cannot find the shut-off valves, you may need to turn off the main water supply to your home.

2. Remove the old drain stopper. Use a Phillips head screwdriver to remove the screws that hold the stopper in place. Once the screws are removed, you should be able to pull the stopper out of the drain.

3. Clean the drain. Before installing the new drain stopper, take a moment to clean the drain. Remove any hair, soap scum, or other debris that may be blocking the drain.

4. Install the new drain stopper. Insert the new drain stopper into the drain hole. Make sure that the stopper is properly seated and that the gasket is in place.

5. Tighten the screws. Use the Phillips head screwdriver to tighten the screws that hold the drain stopper in place. Do not overtighten the screws, as this could damage the stopper or the sink.

6. Turn on the water supply and test the drain. Turn on the water supply to the sink and allow the water to run for a few minutes. Check for any leaks around the drain stopper. If there are no leaks, the drain stopper has been successfully replaced.

Replacing a drain stopper in a bathroom sink is a simple task that can be completed in a few minutes. By following these steps, you can easily replace a worn, damaged, or lost drain stopper and keep your sink functioning properly.