Bathroom Sink Mixer Tap Cartridge Replacement

A leaky bathroom sink mixer tap can be a nuisance. Not only does it waste water, but it can also be annoying and disrupt your daily routine. The good news is that replacing a bathroom sink mixer tap cartridge is a relatively simple task that you can do yourself with a few basic tools.

Identifying the Problem

Before you start replacing the cartridge, you need to identify the problem. The most common cause of a leaky mixer tap is a worn or damaged cartridge. Other possible causes include:

A loose or damaged washer
A cracked or damaged tap body
A faulty O-ring

Gathering the Tools and Materials

Once you have identified the problem, you will need to gather the following tools and materials:

A new cartridge that is compatible with your tap
A wrench or spanner
A screwdriver
A pair of pliers
A bucket or bowl to catch the water
A cloth or sponge

Removing the Old Cartridge

Once you have gathered your tools and materials, you can begin removing the old cartridge.

1. Turn off the water supply to the tap. 2. Open the tap to release any remaining water in the lines. 3. Place a bucket or bowl under the tap to catch the water. 4. Use a wrench or spanner to loosen the nut that holds the cartridge in place. 5. Once the nut is loose, you can use your hands to remove the cartridge.

Installing the New Cartridge

Now that the old cartridge is removed, you can install the new one.

1. Apply a small amount of grease to the O-rings on the new cartridge. 2. Insert the new cartridge into the tap body. 3. Tighten the nut that holds the cartridge in place using a wrench or spanner. 4. Open the water supply to the tap and check for leaks.

Troubleshooting

If the tap is still leaking after you have replaced the cartridge, there may be another problem.

* Check the washer and O-ring for damage and replace them if necessary. * Check the tap body for cracks or damage and replace it if necessary. * If the problem persists, you may need to call a plumber.