Bathroom Sink Tap Replacement

Replacing a bathroom sink tap is a straightforward task that can be completed in a few hours with the right tools and materials. Here's a step-by-step guide to help you through the process.

Gather Your Tools and Materials

Before you start, gather the necessary tools and materials. You'll need: - Adjustable wrench - Allen key (if required) - Basin wrench - New tap - Plumber's putty - Tape measure - Pencil

Turn Off the Water Supply

Locate the water supply valves under the sink and turn them off clockwise. Check that the water is turned off by turning on the tap. Once the water has stopped flowing, you can proceed to the next step.

Disconnect the Old Tap

Use the basin wrench to loosen the nuts that hold the tap in place. Be careful not to overtighten the nuts, as this can damage the tap or sink.

Remove the Old Tap

Once the nuts are loose, you can pull the tap straight up and out of the sink.

Clean the Sink Surface

Use a damp cloth to clean the surface of the sink where the new tap will be installed. This will help to ensure a good seal.

Apply Plumber's Putty

Roll a small amount of plumber's putty into a rope and place it around the base of the new tap. This will help to create a watertight seal.

Install the New Tap

Insert the new tap into the sink and align it with the holes. Tighten the nuts underneath the sink using the basin wrench. Be sure to tighten the nuts securely, but do not overtighten.

Connect the Water Supply

Use the adjustable wrench to connect the water supply lines to the new tap. Tighten the nuts securely, but again, do not overtighten.

Turn On the Water Supply

Slowly turn on the water supply valves under the sink. Check for any leaks around the tap or water supply lines. If you find any leaks, tighten the nuts accordingly.