Fitting A New Bathroom Sink Tap

Fitting a New Bathroom Sink Tap

Giving your bathroom a fresh, updated look can be as simple as replacing the sink tap. While it may seem like a daunting task, fitting a new bathroom sink tap is a relatively straightforward job that can be completed in a few hours with the right tools and materials.

Before you begin, it's important to gather all the necessary tools and materials. You will need:

New bathroom sink tap
Adjustable wrench
Plumbers tape
Basin wrench
Putty knife
Cleaning cloths

Once you have gathered all the necessary tools and materials, you can begin the process of fitting your new bathroom sink tap.

The first step is to turn off the water supply to the sink. There will be two valves under the sink, one for hot water and one for cold water. Turn both valves clockwise to shut off the water supply.

Next, you need to disconnect the old tap. Use the adjustable wrench to loosen the nuts that hold the tap in place. Once the nuts are loose, you can remove the tap from the sink.

Now it's time to install the new tap. First, apply a layer of plumbers tape to the threads of the new tap. This will help to create a watertight seal. Next, insert the new tap into the hole in the sink and tighten the nuts by hand.

Once the nuts are hand-tight, use the adjustable wrench to tighten them further. Be careful not to overtighten the nuts, as this could damage the tap.

Next, you need to connect the water supply lines to the new tap. Use the basin wrench to tighten the nuts that connect the water supply lines to the tap.

Once the water supply lines are connected, turn on the water supply and check for leaks. If there are any leaks, tighten the nuts further until the leaks stop.

Finally, use the putty knife to apply a bead of silicone sealant around the base of the tap. This will help to prevent water from leaking from around the tap.

Congratulations, you have now successfully fitted a new bathroom sink tap!