Fixing A Bathroom Sink Trap

A bathroom sink trap is a curved pipe that connects the sink drain to the main drain line. It prevents sewer gases from entering the bathroom and keeps the water in the sink from running out. If the trap is clogged, it can cause the sink to drain slowly or even overflow. The water in the sink is caused by the loss of the water seal, which is how the trap prevents sewer gasses from entering the bathroom. The water seal must be one inch deep. There are several easy steps that you can take to fix a clogged sink trap. This helpful article will provide instructions on how to fix a bathroom sink trap.

1. Gather your materials. You will need a bucket, a wrench, a pair of pliers, and a new sink trap. If you don't have a new sink trap, you can try to clean the old one with a drain cleaner.

2. Place a bucket under the sink. This will catch the water that comes out of the trap when you remove it.

3. Use the wrench to loosen the nuts that hold the trap in place. Be careful not to overtighten the nuts, or you could crack the trap.

4. Use the pliers to remove the old trap. Be careful not to spill any water on the floor.

5. Clean the old trap with a drain cleaner. If the trap is badly clogged, you may need to soak it in the drain cleaner for a few hours.

6. Install the new trap. Hand-tighten the nuts that hold the trap in place, then use the wrench to tighten them further. Make sure not to overtighten them.

7. Turn on the water and check for leaks. If there are any leaks, tighten the nuts further.

Fixing a bathroom sink trap is a relatively easy task that can be completed in a few minutes. By following these simple steps, you can keep your sink draining properly and prevent sewer gases from entering your bathroom.