How To Adjust Bathroom Faucet Handles

A leaky faucet can be a major annoyance, not to mention a waste of water. If you're dealing with a leaky faucet, the first step is to try to adjust the handle. This is a relatively simple task that can be completed in a few minutes.

Here are the steps on how to adjust bathroom faucet handles:

Turn off the water supply to the faucet. There should be two valves under the sink, one for hot water and one for cold water. Turn both valves clockwise to shut off the water.
Remove the aerator. The aerator is the small screen that screws onto the end of the faucet spout. Use a wrench to unscrew the aerator and remove it.
Loosen the packing nut. The packing nut is located just below the handle. Use a wrench to loosen the packing nut, but be careful not to over-tighten it.
Tighten the packing nut. Once the packing nut is loose, use your fingers to tighten it until the leak stops. Be sure not to over-tighten the packing nut, or you could damage the faucet.
Reinstall the aerator. Screw the aerator back onto the end of the faucet spout.
Turn on the water supply to the faucet. Check for leaks. If there are still leaks, you may need to repeat steps 3-5.

If you've followed these steps and the faucet is still leaking, you may need to replace the washer. The washer is a small rubber or plastic disc that creates a seal between the handle and the faucet body. To replace the washer, you will need to disassemble the faucet. This is a more complex task, so if you're not comfortable doing it yourself, you should call a plumber.

By following these steps, you can easily adjust bathroom faucet handles and stop leaks. This will save you money on your water bill and help you to avoid the annoyance of a leaky faucet.