How To Change Bathroom Vanity Faucet

How to Change a Bathroom Vanity Faucet

Changing a bathroom vanity faucet is a relatively easy task that can be completed in a few simple steps. By following these instructions, you can save yourself the cost of hiring a plumber and have your new faucet installed in no time.

Step 1: Gather Your Tools and Materials

Before you begin, you will need to gather the following tools and materials:

New bathroom vanity faucet
Adjustable wrench
Plumber's putty
Teflon tape
Screwdriver
Bucket
Rags

Step 2: Turn Off the Water Supply

The first step is to turn off the water supply to your bathroom vanity. This is typically done by turning the handles on the shut-off valves located under your sink. If you do not have shut-off valves, you will need to turn off the main water supply to your home.

Step 3: Disconnect the Old Faucet

Once the water supply is turned off, you can begin disconnecting the old faucet. Using an adjustable wrench, loosen the nuts that connect the faucet to the water supply lines. Be careful not to overtighten the nuts, as this can damage the faucet.

Once the nuts are loosened, you can disconnect the water supply lines from the faucet. To do this, simply pull the lines straight up. If the lines are stuck, you can use a pair of pliers to gently pry them loose.

Step 4: Remove the Old Faucet

Once the water supply lines are disconnected, you can remove the old faucet. To do this, simply unscrew the nuts that hold the faucet in place. Be careful not to drop the faucet, as this can damage it.

Step 5: Clean the Sink Area

Before you install the new faucet, it is important to clean the sink area. This will help to prevent any dirt or debris from getting into the new faucet.

To clean the sink area, simply wipe it down with a damp cloth. You can also use a mild cleaning solution to help remove any stubborn dirt or grime.

Step 6: Install the New Faucet

Once the sink area is clean, you can begin installing the new faucet. To do this, simply follow these steps:

Apply a bead of plumber's putty around the base of the faucet.
Insert the faucet into the hole in the sink.
Tighten the nuts that hold the faucet in place.
Connect the water supply lines to the faucet.
Tighten the nuts that connect the water supply lines to the faucet.

Step 7: Turn On the Water Supply

Once the new faucet is installed, you can turn on the water supply. To do this, simply turn the handles on the shut-off valves located under your sink. If you do not have shut-off valves, you will need to turn on the main water supply to your home.

Step 8: Check for Leaks

Once the water supply is turned on, you should check for leaks. To do this, simply run water through the faucet and look for any drips or leaks. If you find any leaks, you can tighten the nuts that connect the faucet to the water supply lines.