How To Fit A Bathroom Sink Trap

How to Fit a Bathroom Sink Trap

Fitting a bathroom sink trap is a relatively simple plumbing task that can be completed in a few easy steps. A trap is a U-shaped pipe that is installed under the sink to prevent sewer gases from escaping into the bathroom. It also collects any debris that may fall down the drain, preventing it from clogging the pipes.

To fit a bathroom sink trap, you will need the following tools and materials:

Adjustable wrench
Plumber's putty
New sink trap
Bucket
Rags

Once you have gathered your tools and materials, follow these steps to fit the bathroom sink trap:

Turn off the water supply to the sink. This is usually done by turning the shut-off valves located under the sink.
Disconnect the old sink trap. Use an adjustable wrench to loosen the nuts that hold the trap in place. Be careful not to overtighten the nuts, as this can damage the trap.
Clean the drainpipe. Remove any debris from the drainpipe using a rag or a pipe brush.
Apply plumber's putty to the new sink trap. Roll out a small piece of plumber's putty and apply it to the rim of the trap where it will connect to the drainpipe.
Install the new sink trap. Place the new trap over the drainpipe and tighten the nuts until they are snug. Do not overtighten the nuts, as this can damage the trap.
Turn on the water supply and check for leaks. Once the trap is installed, turn on the water supply and check for any leaks. If you see any leaks, tighten the nuts until the leak stops.

Fitting a bathroom sink trap is a simple task that can be completed in a few easy steps. By following these instructions, you can save yourself the cost of hiring a plumber.