How To Fit A New Bathroom Sink Tap

How to Fit a New Bathroom Sink Tap

Installing a new bathroom sink tap is a relatively straightforward task that can be completed in a few simple steps. By following these steps, you can ensure that your new tap is fitted correctly and securely, providing you with years of trouble-free use.

Before you begin, it is important to gather the necessary tools and materials. You will need a new tap, a wrench, a screwdriver, and some plumbers tape. Once you have everything you need, you can begin the installation process.

1. Turn off the water supply

The first step is to turn off the water supply to your sink. This will prevent any water from leaking out while you are working. To do this, simply turn the stop valves located under the sink.

2. Remove the old tap

Once the water supply is turned off, you can remove the old tap. To do this, use a wrench to loosen the nuts that are holding the tap in place. Once the nuts are loose, you can pull the tap straight up to remove it.

3. Clean the sink surface

Before you install the new tap, it is important to clean the sink surface. This will help to ensure that the new tap is properly sealed and will not leak. To clean the sink surface, use a damp cloth and a mild detergent.

4. Apply plumbers tape to the new tap

Once the sink surface is clean, you can apply plumbers tape to the new tap. Plumbers tape is a thin, flexible tape that is used to seal the threads of pipes and fittings. To apply plumbers tape, simply wrap the tape around the threads of the new tap, overlapping each wrap by about half.

5. Install the new tap

Now you can install the new tap. To do this, simply insert the tap into the hole in the sink and tighten the nuts that hold it in place. Be sure to tighten the nuts securely, but do not overtighten them.

6. Turn on the water supply

Once the new tap is installed, you can turn on the water supply. To do this, simply turn the stop valves located under the sink back on. Once the water supply is turned on, check for any leaks. If you see any leaks, tighten the nuts that hold the tap in place until the leak stops.