How To Fit A New Bathroom Sink Tap Washer

A tap washer is a small, rubber washer that sits inside the tap and creates a watertight seal. Over time, tap washers can become worn or damaged, causing leaks. Replacing a tap washer is a relatively simple DIY job that can be completed in a few minutes.

There are a few essential aspects to consider when fitting a new bathroom sink tap washer. These include:

The size of the washer
The type of washer
The condition of the tap
The tools you will need
The steps involved in fitting the washer

In this article, we will discuss each of these aspects in detail. We will also provide step-by-step instructions on how to fit a new bathroom sink tap washer.

The Size of the Washer

The size of the washer is important because it must fit snugly inside the tap. If the washer is too small, it will not create a watertight seal and the tap will leak. If the washer is too large, it will not fit properly and may cause the tap to jam.

To determine the size of the washer you need, measure the diameter of the tap hole. The washer should be slightly smaller than the diameter of the hole.

The Type of Washer

There are two main types of tap washers: flat washers and conical washers. Flat washers are made of a thin, rubber material and are used in most taps. Conical washers are made of a thicker, rubber material and are used in taps that have a tapered seat.

When choosing a washer, it is important to select the correct type for your tap. Using the wrong type of washer can cause leaks or damage the tap.

The Condition of the Tap

Before you fit a new washer, it is important to check the condition of the tap. If the tap is damaged or worn, the new washer may not be able to create a watertight seal. In this case, you may need to replace the tap.

To check the condition of the tap, turn off the water supply and remove the tap handle. Inspect the tap for signs of damage, such as cracks or leaks. If you find any damage, you will need to replace the tap.

The Tools You Will Need

To fit a new bathroom sink tap washer, you will need the following tools:

A pair of pliers
A screwdriver
A washer

If you do not have these tools, you can purchase them at your local hardware store.

The Steps Involved in Fitting the Washer

Once you have gathered the necessary tools and materials, you can begin fitting the new washer. The steps involved in this process are as follows:

Turn off the water supply to the tap.
Remove the tap handle.
Using the pliers, remove the old washer from the tap.
Place the new washer on the tap.
Tighten the washer using the screwdriver.
Replace the tap handle.
Turn on the water supply and check for leaks.

If you follow these steps carefully, you should be able to fit a new bathroom sink tap washer successfully. However, if you are not comfortable working with plumbing, it is always best to call a qualified plumber.