Fixing a Bathroom Sink Faucet That Won't Turn Off
A leaky faucet can be a frustrating problem, especially when it's in your bathroom sink. Not only is it annoying to hear the constant dripping, but it can also waste a lot of water and increase your utility bills.
The good news is that fixing a leaky bathroom sink faucet is usually a relatively simple task that you can do yourself with a few basic tools. Here's a step-by-step guide to help you get started:
1. Turn off the water supply.
Before you start working on your faucet, it's important to turn off the water supply. This will prevent water from leaking out while you're working and make it easier to remove the faucet.
To turn off the water supply, simply locate the shut-off valves under the sink. These valves are usually located on the hot and cold water supply lines. Turn the valves clockwise to close them.
2. Remove the aerator.
The aerator is a small screen that's located at the end of the faucet spout. It helps to reduce water flow and create a more even stream of water. Over time, the aerator can become clogged with mineral deposits, which can prevent the faucet from turning off properly.
To remove the aerator, simply unscrew it from the end of the faucet spout. You may need to use a pair of pliers to get a good grip on the aerator.
3. Inspect the washer.
Once you've removed the aerator, you'll be able to see the washer. The washer is a small, rubber disc that sits inside the faucet body and helps to create a seal that prevents water from leaking out.
Inspect the washer for any signs of damage or wear. If the washer is cracked, torn, or deformed, it will need to be replaced.
4. Replace the washer.
If the washer is damaged, you'll need to replace it with a new one. You can find replacement washers at most hardware stores.
To replace the washer, simply remove the old washer and insert the new washer into its place. Make sure that the new washer is seated properly and that there are no gaps around the edges.
5. Reinstall the aerator.
Once you've replaced the washer, you can reinstall the aerator. Simply screw the aerator back onto the end of the faucet spout.
6. Turn on the water supply.
Once the aerator is reinstalled, you can turn on the water supply. Slowly turn the shut-off valves counterclockwise to open them.
Check for any leaks around the faucet. If you see any leaks, tighten the packing nut or replace the O-rings.
7. Test the faucet.
Once you're sure that there are no leaks, turn on the faucet and test it. Make sure that the faucet turns off properly and that there is no leaking.
Conclusion
Fixing a leaky bathroom sink faucet is a relatively simple task that you can do yourself with a few basic tools. By following the steps in this guide, you can get your faucet working properly again in no time.
My Kitchen Faucet Won T Turn Off
Faucet That Won T Shut Off
Faucet Won T Turn Off Tips From A Houston Plumber Santhoff Plumbing
Hot Water Faucet Won T Turn Off Because I Accidentally Left On During Stem Removal Terry Love Plumbing Advice Remodel Diy Professional Forum
Four Reasons Why Your Faucet Won T Stop Dripping Service Plus Plumbing
Bathroom Handle Stiff Or Difficult To Operate
How To Change The Handle Rotation On A Faucet
My Faucet Is Turned Off But The Water Still Running Mr Kitchen Faucets
Bathtub Faucet Won T Turn Off What To Do Alpha Building Inspections
How To Replace A Bathroom Faucet Home Repair Tutor
