How To Fix A Dripping Compression Bathroom Faucet

```html

How To Fix A Dripping Compression Bathroom Faucet

Faucet washer replacement is a simple plumbing chore that takes only a few minutes to complete.

Before starting, turn off the water supply to the faucet. You'll find the shut-off valves under the sink. Once the water is off, open the faucet to release any residual pressure.

Using a wrench, loosen the packing nut, which is located just below the handle. Be careful not to over-tighten the packing nut, as this can damage the faucet.

Remove the handle. Using a screwdriver, remove the screws that hold the handle in place. Once the screws are removed, you can pull the handle off the faucet.

Remove the washer. The washer is a small, rubber disc that sits inside the faucet. To remove the washer, use a pair of needle-nose pliers to gently pry it out of the faucet.

Replace the washer. Take the new washer and insert it into the faucet. Make sure that the washer is seated properly and that it is not twisted or damaged.

Reassemble the faucet. Replace the handle and tighten the packing nut. Turn on the water supply and check for leaks. If there are no leaks, then you have successfully repaired your dripping compression bathroom faucet.

```