How To Fix A Loose Bathroom Sink Stopper

How to Fix a Loose Bathroom Sink Stopper

A loose bathroom sink stopper can be a nuisance, leading to water leakage and an untidy bathroom. Fortunately, fixing a loose sink stopper is a straightforward task that can be completed in a few simple steps.

### Materials and Tools Required - Adjustable wrench or pliers - New washer (if needed) - Silicone sealant (optional) ### Step-by-Step Instructions

1. Remove the Stopper:

- Use an adjustable wrench or pliers to loosen the locknut that holds the stopper in place. - Carefully remove the stopper from the sink drain.

2. Inspect the Stopper and Washers:

- Check the stopper for any damage or wear. - Inspect the washers on the stopper and drainpipe for cracks or deterioration. - Replace any damaged or worn washers with new ones.

3. Apply Sealant (Optional):

- If the stopper and washers appear to be in good condition, you can skip this step. - Apply a thin layer of silicone sealant around the base of the stopper and on the threads of the drainpipe. - Allow the sealant to dry for a few minutes before continuing.

4. Tighten the Locknut:

- Insert the stopper back into the drainpipe. - Use the wrench or pliers to tighten the locknut by hand. - Continue tightening until the locknut is snug but not overtightened.

5. Test the Stopper:

- Run water into the sink and check if the stopper is functioning properly. - If there is any leakage or difficulty operating the stopper, adjust the tightness of the locknut accordingly.

Tips:

- Use a towel or rag to protect the sink and stopper from scratches. - Avoid overtightening the locknut, as this can damage the stopper or the drainpipe. - If the sink stopper continues to be loose or leaks after tightening, there may be an underlying plumbing issue that requires professional attention.