How To Fix Dripping Faucet In Bathroom Sink

How to Fix a Dripping Bathroom Sink Faucet

A dripping faucet is a common problem that can waste water and increase your utility bills. While it may seem like a minor annoyance, a dripping faucet can actually lead to more serious problems down the road, such as corrosion and leaks. Fortunately, fixing a dripping faucet is relatively easy and can be done in a few simple steps.

1. Gather your tools

Before you start, you will need to gather a few tools:

Adjustable wrench
Phillips head screwdriver
Flat head screwdriver
Replacement faucet parts (if necessary)

2. Turn off the water supply

Once you have your tools, you need to turn off the water supply to the faucet. There are usually two shut-off valves under the sink, one for the hot water and one for the cold water. Turn both valves clockwise to turn off the water.

3. Disassemble the faucet

Once the water is turned off, you can disassemble the faucet. First, remove the aerator, which is the small screen at the end of the faucet. Then, use the adjustable wrench to loosen the packing nut, which is located at the base of the faucet handle. Once the packing nut is loose, you can pull the handle off of the faucet.

4. Inspect the faucet parts

Once the faucet is disassembled, you can inspect the parts for wear and tear. The most common cause of a dripping faucet is a worn-out washer. The washer is a small rubber or plastic disc that sits between the faucet handle and the valve seat. If the washer is worn or damaged, it will allow water to leak past it, causing the faucet to drip.

5. Replace the faucet parts

If the washer is worn out, you will need to replace it. To do this, simply remove the old washer and replace it with a new one. You may also need to replace other faucet parts, such as the O-rings or the valve seat. If you are not sure how to replace the faucet parts, you can consult a plumber.

6. Reassemble the faucet

Once you have replaced the faucet parts, you can reassemble the faucet. First, place the new washer on the valve seat. Then, put the handle back on the faucet and tighten the packing nut. Finally, screw on the aerator.

7. Turn on the water supply

Once the faucet is reassembled, you can turn on the water supply. Check the faucet for leaks. If there are no leaks, then you have successfully fixed the dripping faucet.