How To Install A Glacier Bay Bathroom Sink

How to Install a Glacier Bay Bathroom Sink

Installing a new bathroom sink can be a relatively simple and straightforward project that can greatly enhance the look of your bathroom. Before you begin, it's important to gather all the necessary tools and materials to make the process go smoothly. These include a basin wrench, adjustable wrench, putty knife, plumber's putty, Teflon tape, and a new sink, faucet, and drain assembly.

Step 1: Remove the Old Sink

To remove the old sink, first turn off the water supply to the sink. Then, disconnect the water supply lines from the faucet and drain the water from the sink. Next, use the basin wrench to loosen the nuts that secure the sink to the countertop. Once the nuts are loose, lift the sink off the countertop and set it aside.

Step 2: Prepare the Countertop

Before installing the new sink, it's important to prepare the countertop to ensure a proper fit. This may involve cleaning the countertop with a mild detergent to remove any dirt or debris. If you are installing a sink that is a different size than the old sink, you may need to make adjustments to the cutout in the countertop.

Step 3: Apply Plumber's Putty

To ensure a watertight seal between the sink and the countertop, you will need to apply a bead of plumber's putty around the drain hole in the sink. Use your finger or a putty knife to spread the putty evenly around the hole, making sure to create a smooth, consistent bead.

Step 4: Install the Sink

With the plumber's putty in place, carefully lift the sink and position it over the drain hole in the countertop. Slowly lower the sink into place, making sure to align it evenly. Once the sink is in place, tighten the mounting nuts by hand until they are snug. Then, use the basin wrench to fully tighten the nuts.

Step 5: Connect the Water Supply Lines

Take the water supply lines and connect them to the appropriate valves on the faucet. Make sure to use Teflon tape on the threads of the water supply lines to prevent leaks. Tighten the connections by hand, then use the adjustable wrench to fully tighten them.

Step 6: Install the Drain Assembly

The drain assembly consists of the drain body, drain stopper, and overflow plate. Assemble the drain assembly according to the manufacturer's instructions, then insert the drain body into the drain hole in the sink. Secure the drain body with the mounting nut and washer. Finally, install the drain stopper and overflow plate.

Step 7: Check for Leaks

Once the sink is installed and the water supply lines are connected, turn on the water supply and check for leaks. If there are any leaks, tighten the connections or adjust the position of the sink until the leaks are eliminated.

Step 8: Clean Up

Once the sink is installed and leak-free, remove any excess plumber's putty around the drain hole and clean up your work area. Your new Glacier Bay bathroom sink is now ready to use.