How To Install A Single Lever Bathroom Faucet

Installing a single lever bathroom faucet is a straightforward task that can be completed in a few hours. By following these essential steps, you can ensure a successful installation and enjoy the convenience of a new faucet.

Before beginning, gather the necessary tools and materials: an adjustable wrench, a basin wrench, a screwdriver, Teflon tape, and a new faucet. Shut off the water supply to the sink and open the faucet to release any remaining water.

1. Remove the Old Faucet

Using the basin wrench, loosen the nuts that secure the faucet to the sink. Carefully lift the old faucet out of the sink and discard it.

2. Clean the Sink Surface

Clean the surface of the sink where the new faucet will be installed. Remove any old sealant or debris to ensure a secure fit.

3. Install the Mounting Gasket

Place the mounting gasket over the mounting holes in the sink. The gasket should fit snugly and create a seal.

4. Position the New Faucet

Align the new faucet with the mounting holes and lower it into place. Tighten the mounting nuts by hand until they are snug.

5. Connect the Water Supply Lines

Use an adjustable wrench to connect the hot and cold water supply lines to the corresponding valves on the faucet. Tighten the connections until they are secure but do not overtighten.

6. Wrap the Threads with Teflon Tape

Wrap a few layers of Teflon tape around the threads of the faucet spout. This will prevent leaks when the spout is installed.

7. Install the Faucet Spout

Screw the faucet spout onto the faucet body and tighten it with a screwdriver. Ensure that the spout is securely fastened.

8. Test the Faucet

Turn on the water supply and check for any leaks. If there are any leaks, tighten the connections or apply more Teflon tape as needed.

Installing a single lever bathroom faucet is not a difficult task. By following these steps carefully, you can ensure a successful installation and enjoy the convenience of a new faucet.