How To Install Bathroom Sink Pop Up Drain

Installing a pop-up drain in a bathroom sink is a relatively simple task that can be completed in a few minutes. By following these step-by-step instructions, you can easily install a pop-up drain and enjoy the convenience of being able to plug and unplug your sink with a simple push of a button.

Materials you will need:

Pop-up drain assembly
Adjustable wrench
Plumber's putty
Putty knife
Rags

Step 1: Remove the old drain

Start by placing a rag over the drain opening to catch any water or debris that may fall out. Next, use an adjustable wrench to loosen the locknut that holds the old drain in place. Once the locknut is loose, you can remove the old drain by hand. Be careful not to drop any of the parts down the drain.

Step 2: Clean the drain hole

Once the old drain is removed, take a moment to clean the drain hole. Use a putty knife to remove any old plumber's putty or debris. Rinse the drain hole thoroughly with water to remove any dirt or soap residue.

Step 3: Apply plumber's putty

Apply a bead of plumber's putty around the base of the new pop-up drain assembly. The putty will help to create a watertight seal between the drain and the sink.

Step 4: Insert the pop-up drain assembly

Insert the pop-up drain assembly into the drain hole. Be sure to align the drain assembly so that the pop-up button is facing the front of the sink.

Step 5: Tighten the locknut

Use an adjustable wrench to tighten the locknut that holds the pop-up drain assembly in place. Be sure to tighten the locknut securely, but do not overtighten it.

Step 6: Test the pop-up drain

Once the pop-up drain is installed, test it to make sure it is working properly. Fill the sink with water and press the pop-up button to close the drain. The water should stop flowing. Press the pop-up button again to open the drain. The water should drain freely.

Congratulations! You have now successfully installed a pop-up drain in your bathroom sink.