How To Install Lift Rod Pop Up Bathroom Sink Drain

How to Install a Lift Rod Pop-Up Bathroom Sink Drain

A lift rod pop-up bathroom sink drain is a convenient and stylish way to control the flow of water in your sink. It's a simple and inexpensive upgrade that can make a big difference in the look and functionality of your bathroom.

Installing a lift rod pop-up bathroom sink drain is a relatively easy project that can be completed in a few hours. Here's a step-by-step guide to help you get started:

Step 1: Gather Your Materials

You will need the following materials to install a lift rod pop-up bathroom sink drain:

Lift rod pop-up bathroom sink drain
Wrench
Plumber's putty
Rag

Step 2: Remove the Old Drain

Start by turning off the water supply to your sink. Then, use a wrench to loosen the nuts that hold the old drain in place. Remove the old drain and discard it.

Step 3: Apply Plumber's Putty

Apply a ring of plumber's putty around the base of the new drain. This will help to create a watertight seal.

Step 4: Install the New Drain

Insert the new drain into the sink hole and tighten the nuts until the drain is secure. Be careful not to overtighten the nuts.

Step 5: Connect the Lift Rod

Connect the lift rod to the drain by inserting the rod into the hole in the drain. The lift rod should be long enough to reach the pop-up stopper in the sink.

Step 6: Test the Drain

Turn on the water supply to your sink and test the drain to make sure it is working properly. The pop-up stopper should open and close smoothly when you lift and lower the lift rod.

Step 7: Clean Up

Use a rag to wipe away any excess plumber's putty from around the drain.

Conclusion

Installing a lift rod pop-up bathroom sink drain is a simple and inexpensive project that can make a big difference in the look and functionality of your bathroom. By following these steps, you can easily install a new drain in just a few hours.