How To Pull Bathroom Sink Drain Out

How to Replace a Bathroom Sink Drain

A clogged or leaky bathroom sink drain can be a major inconvenience. If you're experiencing these problems, you may need to replace the drain. Replacing a bathroom sink drain is a relatively simple plumbing project that can be completed in a few hours.

Here are the steps involved in replacing a bathroom sink drain:

1. Gather your tools and materials

Before you begin, you will need to gather the following tools and materials:

New drain assembly
Adjustable wrench
Plumber's putty
Flashlight
Bucket

2. Turn off the water supply

Before you can begin working on the drain, you need to turn off the water supply to the sink. This is typically done by closing the shut-off valves located under the sink.

3. Remove the old drain

Use the adjustable wrench to loosen the nuts that hold the old drain in place. Once the nuts are loose, you should be able to pull the drain out of the sink.

4. Clean the drain hole

Once the old drain is removed, you need to clean the drain hole. Remove any debris or old plumber's putty from the hole. You can use a flashlight to get a better look inside the hole.

5. Apply plumber's putty

Apply a bead of plumber's putty around the base of the new drain. This will help to create a watertight seal.

6. Install the new drain

Insert the new drain into the drain hole. Tighten the nuts until the drain is secure. Do not overtighten the nuts.

7. Turn on the water supply

Turn on the water supply to the sink. Check for leaks around the drain. If there are any leaks, tighten the nuts further.

8. Run the water

Run the water through the drain for a few minutes to make sure it is working properly.

Replacing a bathroom sink drain is a relatively simple plumbing project that can be completed in a few hours. By following these steps, you can save yourself the cost of calling a plumber.