How To Put A Bathroom Drain Back Together

How to Put a Bathroom Drain Back Together

Fixing a bathroom drain is a common plumbing issue that can be easily resolved with the right tools and techniques. Understanding the essential components and steps involved in reassembling a bathroom drain is crucial to ensure proper drainage and prevent further damage.

Essential Components:

To put a bathroom drain back together effectively, it's essential to identify the key components involved:

Stopper: The visible part of the drain that prevents water from escaping when closed.
Connecting Rod: A metal rod that connects the stopper to the linkage under the sink.
Linkage: A series of levers that actuate the stopper when the lift rod is operated.
Drain Flange: The metal ring that seals the drain opening to the sink.
Washer: A rubber gasket that creates a watertight seal between the drain flange and the sink.
Mounting Nut: The nut that secures the drain flange to the sink.

Steps for Reassembly:

With the essential components identified, follow these steps to reassemble the bathroom drain:

Remove the Stopper and Lift Rod: Unscrew the cap on the lift rod and pull out the connecting rod and stopper.
Replace the Washer: Fit a new washer onto the drain flange, aligning the tab with the notch on the flange.
Insert the Flange: Align the drain flange with the drain hole and insert it into the sink opening.
Secure the Mounting Nut: Tighten the mounting nut onto the drain flange by hand, then use a wrench to fully secure it.
Reattach the Linkage: Connect the linkage to the drain flange and secure it with the clip.
Reinsert the Connecting Rod: Slide the connecting rod into the slot on the linkage and push it into place.
Install the Stopper: Replace the stopper onto the connecting rod and screw on the cap.

Checking for Leaks:

Once the drain is reassembled, check for leaks by running water into the sink. If there are no leaks, the drain is properly sealed. If leaks persist, tighten the mounting nut further or replace the washer.