How To Put A Bathroom Sink Drain Back Together

Putting a bathroom sink drain back together is a relatively simple task that can be completed in a few minutes. However, there are a few essential steps that must be followed in order to ensure that the drain is properly assembled and functioning correctly.

The first step is to remove the drain stopper. This can usually be done by simply pulling it up from the drain hole. Once the drain stopper is removed, you will see the drain assembly. The drain assembly consists of a few different parts, including the drain flange, the drain body, and the drain tailpiece.

The next step is to remove the drain flange. The drain flange is the part of the drain assembly that is attached to the sink. To remove the drain flange, you will need to use a wrench to loosen the nuts that are holding it in place. Once the nuts are loosened, you can remove the drain flange.

Once the drain flange is removed, you will need to remove the drain body. The drain body is the part of the drain assembly that is located inside the sink. To remove the drain body, you will need to use a wrench to loosen the nuts that are holding it in place. Once the nuts are loosened, you can remove the drain body.

Once the drain body is removed, you will need to remove the drain tailpiece. The drain tailpiece is the part of the drain assembly that connects the drain body to the sink's drainpipe. To remove the drain tailpiece, you will need to use a wrench to loosen the nuts that are holding it in place. Once the nuts are loosened, you can remove the drain tailpiece.

Once all of the parts of the drain assembly have been removed, you can begin to reassemble the drain. To reassemble the drain, you will need to follow the steps in reverse order.

First, you will need to attach the drain tailpiece to the sink's drainpipe. To do this, you will need to insert the tailpiece into the drainpipe and then tighten the nuts that are holding it in place.

Next, you will need to attach the drain body to the drain tailpiece. To do this, you will need to insert the drain body into the tailpiece and then tighten the nuts that are holding it in place.

Finally, you will need to attach the drain flange to the sink. To do this, you will need to place the drain flange over the drain body and then tighten the nuts that are holding it in place.

Once all of the parts of the drain assembly have been reassembled, you can test the drain to make sure that it is functioning correctly. To test the drain, you can simply pour some water down the drain and make sure that it drains properly.