How To Raise An Existing Bathroom Vanity

How to Raise an Existing Bathroom Vanity

Are you looking to give your bathroom a fresh new look without breaking the bank? One of the most effective ways to do so is to raise your existing bathroom vanity. This relatively simple and inexpensive project can make a big impact on the overall appearance of your bathroom. Here's a step-by-step guide on how to do it yourself:

Materials You'll Need:

Wood shims
Screws
Drill
Level
Measuring tape

Step 1: Remove the Vanity

Before you can raise the vanity, you need to remove it from the wall. Turn off the water supply to the vanity and disconnect the plumbing. Remove the screws that are holding the vanity to the wall and carefully lift it off. Be sure to have a helper to assist you, as vanities can be heavy.

Step 2: Level the Base

Once the vanity is removed, you need to level the base where it will be installed. Use a level to check the floor and make any necessary adjustments. If the floor is uneven, you can use wood shims to level it out.

Step 3: Determine the Height

Next, you need to determine how high you want to raise the vanity. The standard height for a bathroom vanity is 32 inches, but you may want to raise it higher or lower depending on your preference. Use a measuring tape to measure the desired height from the floor to the bottom of the vanity.

Step 4: Install the Shims

Once you have determined the height, you need to install the wood shims. Place the shims under the base of the vanity, spacing them evenly apart. Use a level to ensure that the shims are level and that the vanity is at the desired height.

Step 5: Screw the Vanity

Once the shims are in place, you can screw the vanity back into the wall. Use screws that are long enough to go through the vanity, the shims, and into the wall studs. Be sure to use a level to make sure that the vanity is still level.

Step 6: Reconnect the Plumbing

Once the vanity is secured, you can reconnect the plumbing. Turn on the water supply and check for leaks. If there are any leaks, tighten the connections until they stop.

Step 7: Install the Trim

Finally, you can install the trim around the vanity. This will help to hide the shims and give the vanity a finished look. Use a saw to cut the trim to size and then use glue or nails to attach it to the vanity.

Raising an existing bathroom vanity is a relatively simple project that can make a big impact on the look of your bathroom. By following these steps, you can easily achieve a professional-looking result without breaking the bank.