How To Remove And Replace A Bathroom Sink Faucet

Replacing a bathroom sink faucet can be a simple and affordable task that can update the look of your bathroom and improve its functionality. With the right tools and a little bit of time, you can complete this project yourself in just a few hours.

Here Are The Steps You Need To Follow:

1. Shut Off The Water Supply

Before you remove the old faucet, you need to shut off the water supply to your sink. There will be two valves under the sink, one for the hot water and one for the cold water. Turn both valves clockwise to shut off the water.

2. Disconnect The Water Lines

Once the water is turned off, disconnect the water lines from the faucet. There will be two nuts that you need to loosen using a wrench. Be careful not to overtighten the nuts, as you can damage the water lines.

3. Remove The Faucet

Once the water lines are disconnected, you can remove the faucet from the sink. There will be two nuts that you need to loosen using a wrench. Once the nuts are loosened, you can lift the faucet up and out of the sink.

4. Install The New Faucet

Before you install the new faucet, apply a thin layer of plumbers putty to the base of the faucet. This will help to create a watertight seal. Then, place the faucet on the sink and tighten the nuts until they are snug.

5. Connect The Water Lines

Once the faucet is installed, you can connect the water lines. Make sure that the washers are in place on the nuts before you tighten them. Once the water lines are connected, turn on the water supply and check for leaks.

6. Trim The Excess Water Lines

After checking for leaks, use a pair of scissors to trim any excess water lines. This will help to prevent the lines from getting kinked or tangled.

7. Install The Drain

If you are also replacing the drain, now is the time to do so. Apply a thin layer of plumbers putty to the lip of the drain and insert it into the sink hole. Tighten the nuts until they are snug. Then, reinstall the pop-up stopper.

8. Clean Up

Once the drain is installed, clean up the sink and the area around it. Wipe down the faucet, the sink, and the countertop with a damp cloth. Then, remove any tools or materials that you used.