How To Remove Bathroom Spout

Learning how to remove a bathroom spout is an essential task for any homeowner. A leaky or damaged spout can waste water and cause damage to your bathroom. Replacing a spout is a relatively simple task that can be completed in a few hours. By following these steps, you can safely and easily remove your bathroom spout.

Safety First: Before you begin, turn off the water supply to your bathroom. This will prevent water from leaking out of the spout when you remove it. You will also need to gather a few tools, including a wrench, a screwdriver, and a pair of pliers.

Locate the Set Screw: The first step is to locate the set screw that holds the spout in place. The set screw is usually located on the underside of the spout, near the base. Use a screwdriver to loosen the set screw.

Remove the Spout: Once the set screw is loose, you can remove the spout by pulling it straight up. Be careful not to damage the spout or the surrounding area.

Clean the Area: Before you install the new spout, clean the area around the base of the faucet. This will help to ensure a good seal.

Install the New Spout: Apply a thin bead of plumber's putty to the base of the new spout. Then, insert the spout into the hole in the faucet. Tighten the set screw to secure the spout in place.

Turn on the Water: Once the new spout is installed, turn on the water supply and check for leaks. If there are any leaks, tighten the set screw until the leak stops.

By following these steps, you can safely and easily remove your bathroom spout. This is an essential task for any homeowner, and it can help to save you money on water bills and prevent damage to your bathroom.